❏ 4. After applying lubricant to the shaft, re-insert the shaft
into the drive tube and rotate it while slowly pushing it back
into place.
❏ 5. Re-tighten the 1.5mm set screw on the coupler assembly,
making sure that the set screw rests on the flat spot of the drive
shaft. Use thread lock compound on the set screw.
❏ 6. Re-insert the rudder and put the rudder arm back in
place. Re-tighten the 1.5mm rudder arm set screw.
• BOW: The front of the boat
• STERN: The back of the boat
• PORT: This is the left side of the boat when aboard and
facing the front (bow).
• STARBOARD: This is the right side of the boat when
aboard and facing the front (bow).
• HULL: The body of the boat.
• DECK: The top of the boat.
Although it is very enjoyable to go out and run the Reef Racer
by yourself, we think the real fun and excitement is
experienced when you get involved in RACING!
Racing does not have to be an organized and sanctioned
competition to be fun. In fact, small informal races can be
very exciting without the stress that comes with formal events.
Here are some suggestions for setting up a simple racecourse
for boats:
• Make 2 to 4 simple and inexpensive “marker buoys” with
empty milk jugs, string and heavy objects for anchors, similar
to the above sketch.
• For “drag racing” place the buoys similar to the above sketch.
•For “oval racing” place the buoys similar to the above
sketch. NOTE: The above patterns are not based on any sort
of official standards; therefore, you may set up racecourses
any way you desire, using your imagination to make the races
more interesting. Usually the smaller courses will provide
more action and excitement.
The length of the races can be determined by a set number of
laps around the buoys (for example, the first boat to complete
5 laps is the winner); or by time (for example, whoever is
leading at the end of two minutes is the winner).
To order replacement parts for the AquaCraft Reef Racer,
use the order numbers in the Replacement Parts List that follows.
Replacement parts are available only as listed and can be
purchased from hobby shops or mail order/ Internet order firms.
Hardware items (screws, nuts, bolts) are also available from these
outlets. If you need assistance locating a dealer to purchase parts,
visit www.hobbico.com and click on "Where to Buy". If this kit
is missing parts, contact Hobbico Product Support.
REPLACEMENT PARTS LIST
Order # Item
HCAB6307 DECAL SET
HCAB7001 GROMMET/BALL STUD (6)
HCAB7755 PROP SET (2)
HCAB7855 SHAFT SET
HCAB8702 RUDDER SET
HCAB9020 SPEED CONTROL
HCAG3477 MOTOR WITH WIRES
HCAM7033 NIMH BATTERY 7.2V
HCAP0127 BATTERY CHARGER
ORDERING REPLACEMENT PARTS
(24 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales